DO:
- Ensure the Point of Sale is turned ON and connected to the internet.
- Ensure there is enough paper roll in the printer and that it is inserted securely and correctly.
- Ensure the YUMBI GSM Printer is turned ON, is plugged into charge, and remains on at all times. Never turn the GSM Printer off.
- Ensure the YUMBI GSM Printer is positioned near the POS or where everyone can hear it ring when orders start coming in. Adjust the volume to the printer’s loudest setting.
- Ensure that the printer antenna located on the left-hand side is tightly secured and in the upright position (depending on your printer model).
- Ensure the printer is placed in an area where the store has the best network signal. To confirm the connectivity, look for the G and the flashing arrow pointing down that will appear at the top left corner of the GSM printer. These two icons represent a good network connection. Make sure it also has at least 4 signal strength bars showing.
- Check that the printer has a full battery charge, before and after load shedding occurs. The back-up battery only lasts a few hours.
DON'T:
- Position the printer near kitchen stoves and other appliances.
- Place the printer under the counter.
- Turn the printer off at the end of the day.
- Accept orders without reading the printed slip first.
- Cancel orders without reading the printed slip first.
If you have any issues with your YUMBI Printer please contact the Customer Support Team on [email protected]